ATTENTION: This lesson is for advanced users, not for people who do not understand, what is going on!!! REQUIREMENT: Basic knowledges for Windows Operating Systems!!!
--------------------------------------------------------------------------------------------------------------------------
TESTED: Working without any errors and bugs.
Enjoy, Best Regards.
Steps:
1. Download Samsung driver: link, and install it.
2. Download and extract, md5 file CF-Auto-Root-m0-m0xx-gti9300: link
3. Install - run "Odin" from extracted md5 file!
4. Setup your Samsung Galaxy S 3 to use usb debug mode, from > Settings > About device, tap couple of times on Build number to activate your Developers options then, activate usb debug mode!
5. Shutdown your phone, and then press volume down + home + power button, to load bootloader, after loading press volume up!
6. Connect your phone with usb cable in to your computer, and wait to displaying message from Odin software, for openly device!
7. Click on PDA button from Odin software, and load CF-Auto-Root-m0-m0xx-gti9300.tar.md5
8. Press Start button from Odin software, and wait little time...
9. After finish, the phone will to reboot automatically, and you are finished. Congratulation, you are owner on your phone!!!:cowboy:
---------------------------------------------------------
0. After rooted:
1. Install SuperSU
2. Install busybox
3. Install Terminal emulator - for advanced users
4. Flash with TWRP recovery, if you want repeat step 7. But you have to load TWRP file (twrp-3.0.2-1-i9300.img.tar) in to "PDA" TWRP
5. NOTE: When you decide to install custom ROM, you have to use TWRP recovery!
for more, see the screenshots...
--------------------------------------------------------------------------------------------------------------------------
TESTED: Working without any errors and bugs.
Enjoy, Best Regards.
Steps:
1. Download Samsung driver: link, and install it.
2. Download and extract, md5 file CF-Auto-Root-m0-m0xx-gti9300: link
3. Install - run "Odin" from extracted md5 file!
4. Setup your Samsung Galaxy S 3 to use usb debug mode, from > Settings > About device, tap couple of times on Build number to activate your Developers options then, activate usb debug mode!
5. Shutdown your phone, and then press volume down + home + power button, to load bootloader, after loading press volume up!
6. Connect your phone with usb cable in to your computer, and wait to displaying message from Odin software, for openly device!
7. Click on PDA button from Odin software, and load CF-Auto-Root-m0-m0xx-gti9300.tar.md5
8. Press Start button from Odin software, and wait little time...
9. After finish, the phone will to reboot automatically, and you are finished. Congratulation, you are owner on your phone!!!:cowboy:
---------------------------------------------------------
0. After rooted:
1. Install SuperSU
2. Install busybox
3. Install Terminal emulator - for advanced users
4. Flash with TWRP recovery, if you want repeat step 7. But you have to load TWRP file (twrp-3.0.2-1-i9300.img.tar) in to "PDA" TWRP
5. NOTE: When you decide to install custom ROM, you have to use TWRP recovery!
for more, see the screenshots...